All Error Codes
- Code No. 1: Maximum Chamber Temperature Exceeded
- Code No. 2: Steam Generator Overtemperature
- Code No. 3: Process Overtemperature
- Code No. 4: Overpressure Detected
- Code No. 5: Sterilization Pressure Too Low
- Code No. 6: Sterilization Temperature Too Low
- Code No. 7: Drying Pressure Too High
- Code No. 8: Too Many Steam Pulses OR No Water Supply
- Code No. 9: Drainage Fault
- Code No. 10: Chamber Heating Issue
- Code No. 11: Steam Generator Heating Issue
- Code No. 12: Prevacuum / Depressurizing OR Drainage Fault
- Code No. 13: Power Supply Interruption
- Code No. 14: Residual Pressure Detected in Standby Mode
- Code No. 15: Door Locking Mechanism Fault
- Code No. 16: Door Unlocking Mechanism Fault
- Code No. 17: V3 Valve / HEPA Filter Fault
- Code No. 18: Pressure Sensor Fault
- Code No. 19: USB Storage Fault
- Code No. 20: Minimum Chamber Temperature Not Reached
- Code No. 21: Chamber Temperature Sensor Failure
- Code No. 22: Steam Generator Temperature Sensor Failure
- Code No. 23: Process Temperature Sensor Failure
- Code No. 24: Autoclave Temperature Too Low
- Code No. 31: Internal Memory Issue
Vacuum test failed
Problem description:
The device was unable to perform the vacuum test.
Possible Causes:
- A leak in the chamber
- Leaky solenoid valves (V1 / V2 / V3)
- A faulty safety valve
- Issues with the steam generator or pressure sensor
- A worn-out or dirty chamber door gasket, which prevents proper sealing.
How to solve it:
- Clean the gasket. Gently wipe it with a soft cloth and a mild, chlorine-free detergent. Rinse with clean water and dry thoroughly. Do not use sharp tools or aggressive chemicals.
- If the gasket appears worn, deformed, or cracked — replace it.
If the problem persists after cleaning or replacing the gasket, please contact Enbio Service by clicking the button below to fill out the service form.