All Error Codes
- Code No. 1: Maximum Chamber Temperature Exceeded
- Code No. 2: Steam Generator Overtemperature
- Code No. 3: Process Overtemperature
- Code No. 4: Overpressure Detected
- Code No. 5: Sterilization Pressure Too Low
- Code No. 6: Sterilization Temperature Too Low
- Code No. 7: Drying Pressure Too High
- Code No. 8: Too Many Steam Pulses OR No Water Supply
- Code No. 9: Drainage Fault
- Code No. 10: Chamber Heating Issue
- Code No. 11: Steam Generator Heating Issue
- Code No. 12: Prevacuum / Depressurizing OR Drainage Fault
- Code No. 13: Power Supply Interruption
- Code No. 14: Residual Pressure Detected in Standby Mode
- Code No. 15: Door Locking Mechanism Fault
- Code No. 16: Door Unlocking Mechanism Fault
- Code No. 17: V3 Valve / HEPA Filter Fault
- Code No. 18: Pressure Sensor Fault
- Code No. 19: USB Storage Fault
- Code No. 20: Minimum Chamber Temperature Not Reached
- Code No. 21: Chamber Temperature Sensor Failure
- Code No. 22: Steam Generator Temperature Sensor Failure
- Code No. 23: Process Temperature Sensor Failure
- Code No. 24: Autoclave Temperature Too Low
- Code No. 31: Internal Memory Issue
Code No. 7: Drying Pressure Too High
Problem Description:
The pressure inside the chamber is too high during the drying phase.
This issue can occur when:
- The red drain hose is immersed in water, preventing proper drainage.
- The hose is kinked, twisted, or improperly routed, which blocks the free flow of condensate.
- The load is too heavy, interfering with proper pressure regulation during drying.
How to solve it:
- Make sure the red drain hose is not submerged in water.
- Ensure the hose is laid out freely and without bends – gravity should allow water to drain easily.
- Check that the weight of sterilized instruments does not exceed the recommended limits: max. 0.5 kg (S) or 0.8 kg (PRO).
If the issue persists, please contact Enbio Service by clicking the button below to fill out the service form.