All Error Codes
- Code No. 1: Maximum Chamber Temperature Exceeded
- Code No. 2: Steam Generator Overtemperature
- Code No. 3: Process Overtemperature
- Code No. 4: Overpressure Detected
- Code No. 5: Sterilization Pressure Too Low
- Code No. 6: Sterilization Temperature Too Low
- Code No. 7: Drying Pressure Too High
- Code No. 8: Too Many Steam Pulses OR No Water Supply
- Code No. 9: Drainage Fault
- Code No. 10: Chamber Heating Issue
- Code No. 11: Steam Generator Heating Issue
- Code No. 12: Prevacuum / Depressurizing OR Drainage Fault
- Code No. 13: Power Supply Interruption
- Code No. 14: Residual Pressure Detected in Standby Mode
- Code No. 15: Door Locking Mechanism Fault
- Code No. 16: Door Unlocking Mechanism Fault
- Code No. 17: V3 Valve / HEPA Filter Fault
- Code No. 18: Pressure Sensor Fault
- Code No. 19: USB Storage Fault
- Code No. 20: Minimum Chamber Temperature Not Reached
- Code No. 21: Chamber Temperature Sensor Failure
- Code No. 22: Steam Generator Temperature Sensor Failure
- Code No. 23: Process Temperature Sensor Failure
- Code No. 24: Autoclave Temperature Too Low
- Code No. 31: Internal Memory Issue
Code No. 2: Steam Generator Overtemperature
Problem Description:
The temperature in the steam generator has exceeded the operational limit.
This may be due to placing too many instruments inside the chamber — exceeding the recommended load can lead to overheating.
Another possible cause is a malfunction in the steam generator or incorrect interpretation of sensor data by the mainboard. In most cases, this is caused by using improper water.
Remember! Only demineralized or distilled water should be used. The total mineral content must be below 10 ppm, or in terms of conductivity, below 15 μS/cm.
How to solve it:
- Ensure that the sterilized load does not exceed the recommended weight: max. 0.5 kg (S) or 0.8 kg (PRO). Repeat the cycle with a lighter load.
- If the problem persists,please contact Enbio Service by clicking the button below to fill out the service form.